Shrink chuck 4,5° BT 40 - 32 - 100Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

Surface hardened HRC 58~60

Effective from low to high coolant pressures

For the manufacturing of special tools

For d = 60 only with four fi xation screws according to DIN 912

Without wrench

ER-system with spray nozzles

Standard (over 25mm range)

With adjustable spray nozzle and shim

vice clamps

Eingebauter Niederzug

lockable in different positions

A possible increase of axial force during the tapping process is reduced to a minimum