Tool chucks (end mill holders) with clamp screws for flatted cylindrical shank tools - Dimensions of the driving system of tool shanks1 Scope This part of ISO 5414 lays down the dimensions of tool chucks (end mill holders) with clamp screws designed for driving flatted cylindrical shanks in accordance with ISO 3338 2 and specifies the clamp screws used. It also gives the maximum diameter of the chuck nose. This part of ISO 5414 defines two types of drive: chucks with bores of d1 20 mm intended for driving cylindrical shank tools with a single flat, these tools being provided with

The pressures at which these maximum dewpoint temperatures are calculated are in the range 2 MPa (20 bar) to 5 MPa (50 bar)

This standard may be tailored for the specific characteristics and constraints of a space project in conformance with ECSS-S-ST-00

and women and girls

wide series

BS 6898 specifies requirements for a limited range of two types of glass centrifuge tubes for general laboratory use

Measured values will change when any of these conditions significantly changes

It also provides guidance on the procurement of replacement filters

from a whole life value and sustainable development perspective

Parameters for specific hydraulic energy efficiency step-up

BS EN 754-2 on aluminium and aluminium alloys is relevant to:

NOTE: BS EN 15101 does not cover factory-made cellulose products placed on the market as bats

BS EN 6024-1 aims to help you protect the people and property from hazards presented by the electrical or electronic equipment for machinery outlined above