Shrink chuck 3° HSK 63 - 12 - 160Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

Ø 6 – Ø 32 with h6-tolerance

Flute geometry with special design

With high precision coolant you get improved

All tool sizes can be combined

Collets sealed with seal for IC

For mounting straight-shank tools in collet chucks DIN 6499

contact- and hot air shrink units

In this way

chip breaking

Adaptive interface machine direction (ADINTMS): BMT non-driven turret interface -size BT65A

Nubs on the top of the inserts

20 mm only with reduction sleeve)