Shrink chuck 4,5° HSK 63 - 16 - 95Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

5-30mm and 25-50mm range are supplied with setting rings

- display of absolute measuring value or percentage clamping force in relation to reference value

- The main body is made of aerometal

For the coolant supply through the centre of PSK toolholders

Vorschub (Empfehlung): 3

ISO-Metric Thread

Battery :1

SK 30 without coolant exit bores on the end faceDelivery:

Reading parts dull chromed

and vertical

A possible increase of axial force during the tapping process is reduced to a minimum

longer tool life