SR VCT CoverCKS Lab has been working in collaboration with JPN Performance to develop the SR20 VCT Cover. This is a straight replacement for the OEM SR20 VCT cover (will not fit non VCT). Made from billet 6061, this cover will upgrade the tired and old looking factory cover and dress up the engine. This kit includes (rocker cover bolts not included, reuse original bolts), 1x Billet cover 3x M6 x 10mm bolts Installation Instructions Torque supplied bolts to 12nm

5x M6 washers

This is an installation kit only

this cover will upgrade the tired and old looking factory cover and dress up the engine

making sure some has pushed up above the cover (yellow) so the rocker cover gasket can seal against it

1x bracket

3x brackets

alternator

2JZ non VVTi and VVTi GTE variants but not yet tested on 1JZ VVTi (if the OEM bolt holes are the same then should fit also)

These fittings will fit all 1JZ and 2JZ variants

2x 40mm standoff

Kit does include

Wait for sealant recommended amount of time before filling up with coolant and running the motor