Shrink chuck 4,5° HSK 40 - 18 - 95Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

- display of absolute measuring value or percentage clamping force in relation to reference value

Ring gauge accuracy according to DIN 2250Delivery:

5 with h4-tolerance and Ø 6 – Ø 32 with h6-tolerance2

Clamping force preadjustable by graduation lines

ISO 7388-3 - Retention knobs

the coolant tube can be moved only to a minimum degree according to DIN (±1°)

because only the shaft diameters and the squares must fit

Application:

Quick change adaptors with safety clutch are supplied with a predefi ned torque

Spannkraft voreinstellbar durch Rillenmarkierung

automatically inversion of measuring direction

Coolant pressure up to 100 bar