End mill holder Weldon BT 40 - 25 - 35Application: For mounting straight shank tools with lateral flat according to DIN 1835 form B (Weldon). Delivery: With clamping screw All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

clamping depth = 36

- with mode

dust or oil

Coolant nozzles lockable for tools with internal coolant

Angle reading = 10 arcmin

E1= 28 pieces

- digital display with moving bar

vertical and lateral

ER-system with spray nozzles

Drehzahlbereich (Empfehlung): Min

Application:

the control lamp lights up = identification of the reference point