Heat shrinkable low and medium voltage moulded shapes - General requirements (IEC 62677-1:2017)1 Scope This document is applicable to heat shrinkable low and medium voltage moulded shapes in a range of configurations and materials suitable for insulation, environmental sealing, mechanical protection, electrical conductance, anti tracking and strain relief for power cable terminations, joints and stop ends. It specifies the test methods and material requirements. The most commonly available shapes are as shown in the Annex A. Materials which

3 Temperature-controlled chamber

The result obtained will include alkaline pigments contained in the coating of a coated paper

BS 4655 is an international standard that focuses on the determination of pile loss of cut-pile and non-loop pile upholstery fabrics

Advice on the significance of the test result is given in Annex A

Bubble leak testing services

combustion or fusion

BS EN 61300-2-17 on fibre optic interconnecting devices and passive components is useful for:

Vacuum pumps reduce production costs during the manufacturing process

Qualification of electrical installation contractors

It is not mandatory for a certification body to establish certification in all application sectors or to all levels of competence

irrespective of the kind of product

This technical report only applies to installations connected to LV public power systems that supply or may supply other LV loads or installations