Surface chemical analysis. Medium-resolution Auger electron spectrometers. Calibration of energy scales for elemental analysis1 Scope This International Standard specifies a method for calibrating the kinetic energy scales of Auger electron spectrometers with an uncertainty of 3 eV, for general analytical use in identifying elements at surfaces. In addition, it specifies a method for establishing a calibration schedule. It is applicable to instruments used in either direct or differential mode, where the resolution is less than or equal to 0,5 % and the modulation amplitude

given in other appropriate International Standards

the IAQG publishes deployment support material on the IAQG website (see http://www

8 Installation

1) and their routine inspection and pressure testing are outside the scope of this Section of BS 1560 but some guidance is given in Appendix B

— cleaning and maintenance techniques

16 Mechanical strength

testing and fault monitoring of thermally insulated underground piping systems using a steel casing enclosing an insulated service pipe and incorporating an air gap

2 Additional marking were changed

giving consumers confidence when purchasing items in the marketplace

specifies the criteria for circuit integrity of control and communication cables – wires

Why should you use BS EN 60099-4 ‒ Metal-oxide surge arresters

Chapter 4 contains case studies