Liquid crystal display devices - Mechanical testing of display cover glass for mobile devices. Retained biaxial flexural strength (abraded ring-on-ring)1 Scope This part of IEC 61747 is a mechanical performance testing procedure for cover glass used in electronic flat panel displays in mobile devices. This document focuses on the measurement of surface fracture load after flaw introduction via grit particle abrasion. After abrasion, the retained surface fracture load is measured with the method documented in IEC 61747404.

This International Standard specifies the characteristics of locking clips in corrosion-resistant steel for aircraft control wire rope turnbuckles

Who is BS EN 62516 - Terrestrial digital multimedia broadcasting (T-DMB) receivers for

A product certification scheme for continuous production consists of the following stages:

as well as assumptions and boundary conditions that shall be met during the test

BS EN 60216-1 on thermal endurance properties is relevant to:

BS EN 60297-3-102 on the dimensions of an injector/extractor handle is useful for:

The test is performed at a delivery length if the attenuation of the cable is small enough but less than 1/20 of the wavelength of the test signal for measurement with higher frequencies

BS EN 60371-3-2:2006 supersedes EN 60371-3-2:1995

Falling-weight testing machine

13 Electric heating systems

— provides UML definitions of the same datatypes using the terminology

and Buller rings change size