Materials for printed boards and other interconnecting structures - Reinforced base materials, clad and unclad. Modified epoxide woven E-glass laminate sheets of defined flammability (vertical burning test), copper-clad for lead-free assembly

References were adapted

Amendment 1 is planned for September 2018

Enrolment-related terms

Addition of Clause 2 “Normative references”

but exert less effect on the electrical properties

ISO/TS 19278 defines an instrumented indentation hardness test method in the micro scale for quality control of plastics materials and material selection

BS EN 61076-4-115 is a part of an international multi-series standard that focuses on aspects of connectors for electronic equipment

4 Specification of operating modes

This part of the ISO 5167 specifies the geometry and method of use (installation and operating conditions) of orifice plates when they are inserted in a conduit running full to determine the flowrate of the fluid flowing in the conduit

This mitigates risks to life and property

analyzing these data

up to a nominal overall length of 380 mm