G2SC-068-SS Two Piece Clamping Shaft CollarDesign fully engages the shaft without marring. Easily installed where major disassembly would otherwise be required. Provides greater axial holding power than set screw or one piece clamping collars. Effective on both hard and soft shafts. View Catalog Page

Tolerates -5° to 220° F

oil resistant rubber liner which corrects up to 2° misalignment while reducing vibration & noise

Bearing insert is encased in non-conductive

High axial load and torque capacity and does not mar the shaft

Porous flanged bronze bearing is press-fit in sturdy zinc die cast sphere with felt strip for lubrication

Provides torque transmission & alignment

Traditional cost effective rigid coupling design

Provides greater axial holding power than set screw or one-piece clamping collars

Can be mounted vertically or horizontally

Spring-lid oil cap can be positioned 4 ways

Ball Bearing Type

One-Piece Housing has rust-proof plated finish