C133E-643 Locking AssemblySingle taper, self centering design without mounting flange for use in through bored components. Mounted component moves axially during installation. View Catalog PageInstallation & Removal Instructions

self-centering design with mounting flange for use in through-bored components with smaller pitch/outside diameters

Provides greater axial holding power than set screw collars

Mounted component moves axially during installation

Single-taper

high impact and abrasion

Design fully engages the shaft without marring

self-centering design for use in through-bored components with extremely high torque and/or bending requirements

Easily installed where major disassembly would otherwise be required

Housing is crimped together at bolt holes

These unique two-piece rigid clamping couplings come with an undersized ID

Acetal Copolymer collars will not rust or corrode

Bearing insert is encased in non-conductive