Hydraulic expansion chuck HSK 50 - 06 - 80Application: For mounting straight shank tools acc. DIN 1835 form A+B+E and DIN 6535 form HA+HB+HE (larger than dia. 20 mm only with reduction sleeve). Delivery: Without wrench All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

ISO-Metric Thread

Unit Selection : Nm

Adapters ISO / PSK with axial clamping

For mounting straight-shank tools in collet chucks DIN 6499

With balanced clamping nut All holders are made of forged steel

bei Ø 6 – Ø 32 mm = h235

- Especially suitable fore wire EDM

The tapered tool holder is thus optimally

Thread configuration with a special design

Soft body for later processing

For the chucking of quick change adaptors for taps

clamping depth = 50