Geometrical product specifications (GPS). ISO code system for tolerances on linear sizes - Tables of standard tolerance classes and limit deviations for holes and shafts1 Scope This part of ISO 286 gives values of the limit deviations for commonly used tolerance classes for holes and shafts calculated from the tables given in ISO 2861. This part of ISO 286 covers values for the upper limit deviations ES (for holes) and es (for shafts), and the lower limit deviations EI (for holes) and ei (for shafts) (see Figures 1 and 2). NOTE In the tables of limit deviations, the values of the upper limit deviation ES or es are

This European Standard applies to brake discs designed to be fitted to railway vehicles

it is essential that the heating equipment comply with best industry requirements to ensure they are safe and effective when in use

3 Dynamic performance of object detection

Who is BS EN 1991-1-4 - Wind actions on structures for

Manufacturers of products that provide audio output (televisions

In addition to the requirements specified within this International Standard

Digital data transmission systems fall basically into two categories working at data rates either above or below 100 kilobits/second

thus reducing uncertainty

Interlayer bonding

BS EN 2240-038 specifies the required characteristics for the lamp

BS EN 3553 provides the material designation

free-fall method