Specification for nickel-iron-chromium-molybdenum-aluminium-titanium heat-resisting alloy billets, bars, forgings and parts (Ni/Co 43.5, Cr 16.5, Mo 3.3, Al 1.2, Ti 1.2, Fe remainder)1 Scope This British Standard specifies requirements for nickel iron chromium molybdenum aluminium titanium heat resisting alloy supplied in the following forms, and as parts. a) Bars and extruded sections for machining: solution treated, designation HR 55A. b) Extruded section for subsequent forming: softened, designation HR 55B. c) Billets and bars for forging: hot or cold worked and subsequently machined or ground, designation HR 55C. d) Forgings:

installation planning

angle and crescent test pieces

It applies only to the manufacture and use of electronic devices

as well as the European test methods for asphalt covered by the BS EN 12697 series

The method is applicable to all nitrogenous fertilizers

use or recycling of aluminium products

Gaseous mixtures containing hydrogen gas

01 to 10 Cr2O3 0

and high performance are important

that provides information for integrating IEC 61784-2 CPF 15 (Modbus TCP®) and Modbus Serial Line®1 protocol support into Field Device Tool (FDT) systems based on COM implementation

BS EN 136002 is an international standard used for Harmonized system of quality assessment for electronic components

and hence not given in BS EN 60811‑1‑1 to BS EN 60811‑4‑1