Shrink chuck 4,5° BT 30 - 08 - 80Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

In the tailstock of the lathe so that no friction between the workpiece and the tip occurs

E2= 14 pieces

Calibration of the angular position of spindles of milling-turning centres

With fi ne adjustment carriage to feed the slider finely

- Bed height H: 0

clamping depth = 61

Test certificate

For mounting tools with straight shanks

In this way

chip breaking

no adhesion occurs and the tool

The internal thread provided for the coolant tube in the PSC toolholder is plugged with the socket-head screw incorporated in the adapter