End mill holder Weldon HSK 100 - 32 - 160Application: For mounting straight shank tools with lateral flat according to DIN 1835 form B (Weldon). Delivery: With clamping screw All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

Clamping capacity up to –0

Calibration certificat

Alignment of component reference surfaces or edges

Upon switching on the display will read the actual absolute measuring position

Stem diameter: Ø 8mm h6

T-nuts 18mm

break-proof and impact-resistant ABS plastic

For holding tool holders with polygonal shank ISO 26623-1

The insert is clicked into our grid system with

Metal housing with rotating lever gauge

After mounting

Clamping positions: horizontal and vertical