UCPL206-17 1-1/16" Standard Duty Low Shaft Set Screw Locking Pillow Block BearingClick here for spec sheet: UCPL Spec Sheet

Provides greater axial holding power than set screw collars

-60° to 180° F temperature range

Entire unit is UHMW-PE

Design fully engages the shaft without marring

non-self-centering design for use in counter-bored components

For applications involving slow rotating or linear motion

Click here for spec sheet: UCPX Spec Sheet

Self-lubricating ideal for wet or harsh environments where wash down is required

Does not mar the shaft

Allows you room to re-bore the ID without damaging the clamp screws

Two-piece stainless steel housing units

oil resistant rubber liner which corrects up to 2° misalignment while reducing vibration & noise