Engine Crankcase Breather CapNo more stamped steel breather caps for aluminum valve covers! Complete your engine dress up look with a breather cap that actually matches your look! These new Slant Edge aluminum push in breather caps are available in five different finishes, and with just about every Bowtie emblem configuration imaginable: raised and milled, recessed with inlaid paint, the unique recessed raised blackfield, and even no emblem at all. The vivid 3D Bowtie emblem

This is critical as it properly locates the sway bar and prevents lateral movement during hard cornering maneuvers

Adjustment of the upper control arm allows pinion angle changes for suspension set-up and suspension correction when a vehicle has been lowered

thanks to factory plug-in connectors and a premade wiring harness taking less than 1

high pressure OE-spec transmission or engine oil hose has an inside diameter of 3/8" and comes in pre-cut length of 25'

4" discs utilize solid hubs (possible gear noise) to reduce the rotational weight on the input shaft for quick clean shifts

To top it off

while a new secondary shaft throttle stop adjustment provides even more precise idle airflow adjustment and balance

The rear features adjustable tubular frame braces

Precision computer numerical control (CNC) manufacturing ensures an accurate fit and best of all

Installation time is about 1-2 hours

and has a high operating temperature and maximum pressure rating so that it can get your fluids where they need to be in nearly any condition

in conjunction with a Snell or FIA rated helmet and a 3-point harness