2926V546 Multi-Speed BeltsGates Multi Speed belts are manufactured with a banded or bandless construction featuring high modulus, fiber loaded stock that offers transverse rigidity and flexibility for higher load capacity and longer service life on your variable speed drives. Notch Design reduced thermal and bending stresses for longer life. Smooth running construction for minimal vibration at high speeds. Uniform composition and thickness of the undercord ensure smooth and

self-centering design with mounting flange for use in through-bored components with smaller pitch/outside diameters

For ultra hard aggregate

• 135º split point provides fast penetration and accurate starting without a center punch

You can vary motor speed between 300 and 3

Rip cut: 24" x 24" tile

Click here for spec sheets: SUCNPFCS Spec Sheet

Regulating Range 7 - 125 PSI (0

• Black oxide surface finish increases wear resistance and adds lubricity to improve chip flow

Cut-off wheel for gas powered saws

MEDIUM BOND WET CONCRETE BLADES

This means that a smaller regulator is installed and is used to adjust the R2000 Regulator

Seats are silicon rubber to provide a long leak free service life