Rubber, vulcanized or thermoplastic. Low temperature testing. General introduction and guide1 Scope This International Standard provides a general introduction to, and guidance on, the methods of test for low temperature properties of vulcanized and thermoplastic rubbers. It is intended to provide an understanding of the significance of the various low temperature properties and to assist in the selection of an appropriate test method.

2 Performance standard

BS EN 12309-5 also mentions requirements for cooling and heat capacity rating and energy performance

BS EN IEC 62271‑209:2019 supersedes BS EN 62271‑209:2007

type A 2 sliding plates

The revision also takes into account HSG 282 - Control of legionella and other infectious agents in spa-pools – a system that was published in January 2017

Style is not intended to define material or design

BS EN 1034-5 focuses on safety requirements for sheeters

more and more organizations are recognizing the need to include environmental performance in the design of their products

embedded heating and cooling systems

NOTE 1: Construction products include e

in the event of static flood water rising up to a level between 600 mm and 900 mm above ground level

Part 4 - Forms of products (withdrawn)