Dentistry. Multifunction handpieces1 Scope This document specifies requirements, test methods, instructions for use and marking for multifunction handpieces (colloquially called syringes) intended to be used in the oral cavity of the patient. This document does not apply to dental handpieces and motors, intraoral cameras, dental polymerisation lamps, powered scalers, powder jet handpieces, prophy handpieces, suction cannulas and saliva ejectors.

Using PD IEC TR 62357‑2 you can establish the list of use cases developed by TC 57 and Power systems management and associated information exchanges

BS 5502-52 is the 52nd part of the BS 5502 series that gives recommendations on the design and selection of alarm systems

ISO/IEC 20006-3 provides guidelines regarding the aggregation of competency information and data

Who is BS EN IEC 63041‑2- Chemical and biochemical piezoelectric sensors for

Press fittings (also known as crimp fittings) are crimped

services and control points defined in the propoded DCP to be deployed in the home network environment and to enable management of incoming and outgoing telephony calls

and icing should also be considered

What is ISO 5182 - Materials for electrodes and ancillary equipment for resistance welding about

Can be used as a part of RFID systems where the interrogator is: used in the aircraft while on the ground installed on ground equipment

BS ISO/IEC 27000:2014 serves two functions:

Why should you use BS EN 15365 -  Creep behvaiour of ceramic fibres

Sampling flow rate