Tool chucks (end mill holders) with clamp screws for flatted cylindrical shank tools - Connecting dimensions of chucks and designation1 Scope This part of ISO 5414 specifies the dimensions of tool chucks (end mill holders) with clamp screws for tools with flatted cylindrical shanks in accordance with ISO 3338 2. It also specifies the designations of these chucks. Two types of connection are defined: chucks with 7 24 taper shanks in accordance with ISO 297 for manual changers and with ISO 7388 1 for automatic changers, for tool shanks with either single flat or a double flat for

The fifth group of three digits identifies the nominal diameter of the working part of the instruments

2 An Introduction to Culture within KM

2 Control environment for SAM

BS EN 10293 applies

BS 7799-1:2005

Demonstrates how privacy enhancing technologies (PETs) can be used as privacy controls

It also provides the framework

maturity rapidly and

Test laboratories of steel products

Note: As a language

50 Hz systems

Medical device manufacturers and installers that include sterilizers in their service