End mill holder Weldon HSK 63 - 10 - 130Application: For mounting straight shank tools with lateral flat according to DIN 1835 form B (Weldon). Delivery: With clamping screw All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

5 with h4-tolerance and Ø 6 – Ø 32 with h6-tolerance1

Entirely hardened and grinded on the inside and outside

For mounting milling cutters with transverse or longitudinal groove

All holders are made of forged steel

critical factors for successful deep face grooving operations

clamping depth 2 mm

The base is designed with a thermal heat isolation hand grip

Low material loss

With balanced clamping nut All holders are made of forged steel

0V Battery

5 with h4-tolerance and Ø 6 – Ø 32 with h6-tolerance7

no adhesion occurs and the tool