Thermoplastics pipes and fittings. Vicat softening temperature - General test method1 Scope This part of ISO 2507 specifies a general method for determining the Vicat softening temperature of thermoplastics pipes and fittings. It includes the adaptation of method of ISO 306: 1994, using a force of 50 N. This method is applicable only to thermoplastics materials for which it is possible to measure the temperature at which their rate of softening becomes rapid. It is not applicable to crystalline or semi crystalline polymers.

Terms and definitions have been updated to reflect the BS ISO 15686 series

BS ISO 10312:2019 supersedes ISO 10312:1995

Testing houses and facilities

for the external mechanical stress type whisker covered by this standard

Assessment of whether test results indicate conformity to the labelling based upon a stipulated tolerance

it is not intended that this Part of BS 5958 be used to obtain guidance on the protection of structures against lightning

Paper and board online measuring equipment is mostly based on different technology to that of laboratory equipment

The interaction between these loads and the voltage supply is often the cause of degraded power quality on the demand side

This standard does not specify these modes and so it is not possible to use this standard on its own

Why should you use BS EN 62680-2-1 - USB 2

Compression strength

The general technical delivery conditions in EN 10021 also apply