Memorials within burial grounds and memorial sites. Specification1 Scope This British Standard specifies the minimum structural design criteria and performance requirements for new and reinstated monolithic and multi component memorials in burial grounds and memorial sites in which memorials are: a) fabricated from natural stone and or concrete; and b) installed above and below the natural ground surface; and c) whose total mass does not exceed 4 t. NOTE 1 Memorials of a mass greater than 4 t are required to be

Manufacturers of printed board circuits

BS EN 4199-002 guides you through the reference Index of product standards for bonding straps for aircraft for aircraft industry

BS EN 13360 is applicable to single-face

the module’s performance at different irradiance levels

BS EN ISO 10993-12:2009 Biological evaluation of medical devices

Transport service users

Annex B (normative) Illustration of ball gauges and sorting principles

The page numbers in Chapter 6 are preceded by “6-“

The terms 'flow diameter' and 'spread' are interchanged

The scope was adjusted and revised

This document defines an exchange format for target input values

especially at a time when all consumers are looking for safety in packaging