AEM 97-01 Prelude Blue Cold Air Intake (NLA)The AEM 21 406B Performance Cold Air Intake System produces horsepower and torque gains by replacing your vehicle's restrictive factory air filter and air intake housing. This air intake system was designed, tuned and dyno tested to fit specific Honda Prelude models. Air enters the system through an oversized AEM Dryflow synthetic washable air filter for outstanding air flow, filtration and performance. The air filter is relocated to the passenger

You’ll notice both control arms have a spindle option – be sure to select the same spindle option as the Engine Swap Kit to ensure compatibility

Fully machined inlet and outlet to prevent boost leaks

and still wanting to run vacuum to the crankcase

which ultimately results in a long-lasting part with consistent performance and comfort

Dramatically increases the volume of fuel displaced by the HPFP by 41%

- Drill bit - 11mm step bit & 4mm pilot bit

Every King bearing utilizes the highest quality materials and the most advanced designs to ensure complete customer satisfaction

- Thermostat Housing Cover

5 mm on the 228i/230i/320i/328i/330i/428i/430i which means the new bar can be adjusted from 61% to 93% stiffer than the stock front sway bar

designed for a 5x114

No Check Engine Lights (CEL or DTC codes)

Only for vehicles which have electronic dampers