3 Pin PCB Terminal Block 7.5mm Pitch 20A Rating ZB429Terminal blocks (also known as screw terminals) are electrical connectors that allow you to connect wires in the same circuit without cutting or splicing them. Screw with 3 pins. The Terminal Block is a multifunctional and small terminal block. It's used to connect wires to the circuit board. The terminal block's small size allows it to connect two conductors on a PCB where space is at a premium. The wires are held in place by screws on this terminal

6k ohm 2W and tolerance of ±5%

Isolated IGBT/MOSFET gate drive

Gold for these 1K5 resistors

Battery: 2*CR2016 3V (included)

Power-on Reset (POR)

These are Metal Film Resistor with a value of 120 ohm 1W and tolerance of ±5%

400W at room temperature

you may use GSM/GPRS technology to communicate with this development board

The most standard DC female jack is the 2

and an external PCB antenna that may be connected to your board

thermal protection is made

Texas Instruments