Paints and varnishes. Coating materials and coating systems for exterior wood - Determination of the adhesion on wood after water exposure by a double-X-cut test1 Scope This document describes the method for assessing the resistance of paint coatings to separation from substrates when a double X pattern is cut into the coating, penetrating through to the substrate and using a tape. Where a measurement of adhesion is required, the method described in CEN TS 9279 can be used. The double X cut pattern has been especially designed for wood and wood like substrates to minimize the effects from the incisions and at

Who is BS EN 12280-1 – Accelerated ageing tests for

It also identifies energy efficiency aspects and promotes an understanding of how systems or devices can become more energy efficient

as described in this technical report

Why should you use ISO 21250-2

alumina as the dominating phase in the composite with a mass fraction of >60 %

In order to protect human skin from the deleterious UV radiation of sunlight

The bends and tees specified are for use with tubes of outside diameters 12

ISO/IEC 21118 specifies the information to be included in the specification sheets for front projection type data projectors and the form of specification sheets

or if agreed between a customer and a manufacturer

The assembly consists of the following components:

They also relate to the safety of others present in the vicinity

Evaluation of stability of in vitro diagnostic reagents