Water quality. Determination of selenium - Method using hydride generation atomic absorption spectrometry (HGAAS)1 Scope This part of ISO TS 17379 specifies a method for the determination of selenium. The method is applicable to drinking water, surface water, ground water, and rain water. The dynamic range of this part of ISO TS 17379 is approximately 0,5 g l to 20 g l. Samples containing selenium at higher concentrations than the application range can be analysed following appropriate dilution. The method is unlikely to detect organoselenium compounds. The

high concentrations of extracellular polymeric substances (EPS)

test and measurement requirements and severities which a fibre optic pigtailed 1 490 / 1 550 nm downstream and 1 310 nm upstream wide wavelength division multiplexing (WWDM) passive optical network (PON) device must satisfy in order to be categorized as meeting the requirements of the category C (controlled environments)

Power supply

6 Iris image format specification

additional safety requirements are necessary which are not covered by BS EN 15027

Why should you use BS 4317-2-Determination of moisture content of cereals and cereal products

and travel time data

BS EN 60896-22 does not apply to lead-acid cells and batteries used for vehicle engine starting applications (IEC 60095 series)

This Part of BS 5228 should be read in conjunction with BS 5228-1

such as gas-tight barriers or areas with high-pressure differentials

Guidance is presented for the selection of critical parameters in confirmatory test designs

Conformity assessors of a service provider’s service management system to the requirements in this part of ISO/IEC 20000