Pitman Arm for Clipper Models 47A & 47BThis pitman arm goes on the the 47A and 47B models. It may fit other clipper models as well. You will have to reference the part numbers listed in your parts book. This part is used to connect the eccentric shaft to the shoe of the seed cleaner. Note that right hand and left hand are determined by facing the end of the cleaner where you insert the screens. Note: If you have a clipper pitman arm that is not listed in our store you can ship us your used

This Support bracket is for the Eliminator 224 Auger

Capacity approx BPH on barley

Please see pictures to see where it goes

67 and 297

If buying for a cotton seed hopper

We made a video going over the installation of this unit

and axle with hardware

This shaft is ¾” in diameter and is 33” long

These sprockets are also used on Clipper M-2Bs that have the updated cable kit installed on the older brush drive system

This H-frame includes rollers and axels

The clipper factory part number is F098-02401

It may also be possible for you to purchase this shaft pivot collar and bore the shaft hole to 13/16”