Shell mill holder SK 40 - 40 - 30Application: For mounting milling cutters with transversal groove. Note: d = 40 d = 60: For large diameter face mill cutters with four additional threaded holes according to DIN 2079. SK 30 without coolant exit bores on the end faceDelivery: With drivers, cross head retaining screw and cylinder head retaining screw for cutters with central coolant. For d = 60 only with four fi xation screws according to DIN 912. All holders are made of forged steel

For the coolant supply through the centre of PSK toolholders

Ersatz-Reinigungs-Propeller Typ 330mm

Measuring contact points are designed to allow measurements near to the bottom of blind holes

For the manufacturing of special tools

- IP65 degree of protection

bei Ø 6 – Ø 32 mm = h237

Strength class:

is prevented from attaching itself by vacuum

Positionier- und Halte-Pin

pieces and tables

There is no need to set the zero position each time the caliper is used as the origin setting is retained even when the caliper is switched off

right angularity: 0