DOUBLE ROPED CIRCLE DIE SET - Gina Marie DesignsMeasures approx 4x4 largest layer When using steel dies I like to reccomend for machines that need 2 plastic cutting plates to keep one new and use the other to cut into. Make sure you are flipping the one your cutting into to help reduce the wave that will happen with excessive cutting. Keeping one plate new at all times helps the die not need to flex to two plates and only one. I find you typically get a better cut using this trick! Plate dies and

You need to follow the tips below if you have difficulties

65 tall by 3

Our $10 dies would have cost $10 to manufacture here so we made sure to pass the savings onto our customers

The inner lattice panel is VERY tiny and petite

Die is approximately 4

Each measures approx 3x3

Measurements

Largest die layer measures 4x4

Dies measure approximately 3 inches tall

If your pouch arrives open in your package please make sure you carefully check the bubble mailer for any letters

Measures 2

A code for the gift card will be generated and emailed to the purchaser typically within 48 hours