Tubi Valved Exhaust for Aventador STubi design reduces weight and heat within the Aventador S. The valves retain factory sound control, allowing an OEM+ note or a high pitched scream. By following the OEM layout the Tubi with a 70mm (2. 75") diameter, the exhaust emphasizes the stock powerband. Stainless Steel Construction Made to order.

No matter where in the world

The result is a short

Updated Version with Archer Racing Dust Boot and revised Grease Points to allow for easier servicing

and Goodridge braided stainless steel lines with stainless steel fittings

100% Made in the USA - Never Outsourced

load rating

6lbs lighter per rotor than OEM and a complete set of 4 is 34

driving excitement

driveline weight and driveline movement of the H1 put a large amount of stress on the rubber sway bar mounts and they wear away so there is less support of the bar - by replacing with Hyper-Flex polyurethane mounts it provides maximum performance of the sway bars

Fits 2018+ Tesla Model S & Model X NON-PLAID / LONG RANGE

IPSCO 10mm require extended lugnuts or extended wheel studs

Brembo 380mm x 34mm (15") lightweight two piece rotors (front & rear)