Preparation of steel substrates before application of paints and related products. Specifications for metallic blast-cleaning abrasives - General introduction and classification1 Scope This document describes a classification of metallic blast cleaning abrasives for the preparation of steel substrates before application of paints and related products. It specifies the characteristics which are required for the complete designation of such abrasives. This document applies to abrasives supplied in the "new" or unused condition only. It does not apply to abrasives either during or after use. NOTE Although this document has been

to be used for colour characterization and colour management of front projection displays in multimedia systems

Save when you buy BS EN 1990:2002 and the National Annex together

BS EN 1645-1 is the first part of a series of documents on leisure accommodation vehicles

Why should you use BS EN 62310-1 - Static transfer systems

small containers

NOTE The document describes the current state of the art of multivariate control charts that are being applied in practice nowadays

The time stamp indicates the intended delivery time of the first bit/byte of the transport stream packets from the receiver output to the T-STD (Transport Stream Target Decoder)

BS EN 13312-1 aid manufacturers in the classification of couplings

Note: BS EN 12312-12 is not applicable to potable water service equipment which is manufactured before the date of publication of BS EN 12312-12 by CEN

of cylindrical threads

Starch products are used in the meats industry for moisture management

ISO 14405-2 illustrates the ambiguity caused by the use of dimensional specifications to control properties other than linear or angular size and the benefit of using geometrical specifications instead