Stead 10 Ohm 100W Wire Wound Potentiometer ResistorIt is a 100W 10 Ohm wire wound variable rotary Potentiometer resistor. Its resistive part is rotary. The wiper in this type is mounted on a shaft and the movement of this shaft will change the length and resistance. Basically it is a variable or adjustable rotary Potentiometer resistor work as when rotate the wiper then resistance will be vary. A Potentiometer is a variable or adjustable resistor that can control the electrical resistance of a circuit

such as the Sense HAT

Their low stored charge and hyperfast soft recovery minimize ringing and electrical noise in many power switching circuits reducing power loss in the switching transistors

It accomplishes this by functioning as an inductor and reacting to the magnetic field created by a current-carrying conductor

And it stays in its position until it is not pressed again to change its position

Working Temperature -25°C to 70°C Working Humidity 20~90% RH Dimensions(L*W*H) 159*97*38mm

the Echo pin outputs a high level

The detection distance can be increased or decreased using a potentiometer while the delay time can be increased or decreased using the other potentiometer

No Load Current @10V 0

the design of the metallic case enhances the heat dissipation of LRS-200-24 that operates from -25°C to 70°C under air convection without a fan

The device operates between 1

Minimum Supply Voltage (V)

At the inputs