Test conditions for machining centres - Geometric tests for machines with vertical spindle or universal heads with vertical primary rotary axis (vertical Z-axis)1 Scope This part of ISO 10791 specifies, with reference to ISO 230 1, the geometric tests for machining centres (or numerically controlled milling machines, boring machines, etc., where applicable) with vertical spindle (that is vertical Z axis). This part of ISO 10791 applies to machining centres having basically three numerically controlled axes, that is three linear axes (X, Y and Z) of up to 2 000 mm length, but also refers to supplementary

The guidelines provided in BS EN 3645-009 helps to select the right receptacles covers as well as a connector as they improve the production process and if an electronic component fails

which are not explicitly referenced here and for which harmonized European Standards are not yet available

references to IEC 61672-1

Who is BS EN 13160-3 - Liquid level in the leak detection liquid tanks for

TC 77 and its sub-committees are prepared to co-operate with product committees in the evaluation of the value of particular immunity test levels for their products

Why should you use ISO 16063-34 - Calibration of vibration and shock transducers

The gas and steam industry

The electrical aspects of electrically powered lawn trimmers and lawn edge trimmers are not covered by this standard

This document does not cover motorized cleaning heads for which additional requirements are under consideration

BS 3445-1 is the first part of a multi-series standard that covers specifications for water trough bodies

The publication defines the immunity test requirements for equipment within its scope in relation to continuous and transient conducted and radiated disturbances

infra-red analysis