Shrink chuck 4,5° PSK 40 - 12 - 75Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of

Hardening depth 0

With wrench

Delivered with a built-in screw for shortened taper tools

Measuring contact points are designed to allow measurements near to the bottom of blind holes

quantity of inserts:

Battery :1

ISO 7388-3 - Retention knobs

In machining centres (machines with automatic tool changers)

6 µm radial run-out with a 5 µm clamping nut

Plug gauge sizes according to DIN 2245

With retaining screw

4 und 5 mm = h4