End mill holder Weldon BT 50 - 32 - 160Application: For mounting straight shank tools with lateral flat according to DIN 1835 form B (Weldon). Delivery: With clamping screw All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

5 with h4-tolerance and Ø 6 – Ø 32 with h6-tolerance1

- The main body is made of aerometal

Ground on the inside and outside

PSK = PSK 50

and are noted for their tailored inner struts

With fi ne adjustment carriage to feed the slider finely

154 x 54 x 17

For the coolant supply through the centre of  HSK toolholders

For mounting tools with straight shanks

depths and steps

On machining centres without synchronised spindles

Not applicable with reductions