Preparation of steel substrates before application of paints and related products. Specifications for non-metallic blast-cleaning abrasives - OlivineWhat is this standard about? This document specifies requirements for olivine abrasives, as supplied for blast cleaning processes. It specifies ranges of particle sizes and values for apparent density, Mohs hardness, moisture content, conductivity of aqueous extract and water soluble chlorides. The requirements specified in this document apply to abrasives supplied in the "new" condition only. They do not apply to abrasives either during or after use.

the method may be used only if they can first be completely removed by a method not affecting the oxygen content of the powder

Pressurized enclosures where the containment system may release air with an oxygen content greater than normal

residential care/nursing homes

NOTE 1 Manufacturers are encouraged to incorporate the reservoir connectors specified in the ISO 18250 series into medical devices

AIS search and rescue transmitter (AIS-SART)

Some other standards referring to individual test methods enumerate in reverse order

Annex A (normative) Method of test for similar flow from needles

avoid environmental problems related to oil leakage

and in greater detail

For multiple sheets and full press runs

glassware and glass ceramicware:- chemical composition

you can be ensured of the grades of continuously hot rolled low carbon steel sheet and strip