DFRobot SEN0104 Mini Touch Sensor KitPower supply: 3. 3 5v Pin definition: Digital output (Green wire), Power (Red wire), GND (Black wire). Product comes with: 1x ITA Touch module with Digital sensor cable, 1x 3x3cm copper with the sticky part, 1x 15cm wire. Note: This sensor requires some basic soldering This is a cool touch sensor from DFRobot. You can hook it up to the IO Expansion shield (for arduino) directly. It includes a metallic tape with a sticky side. This makes it possible

Length accumulation and subtraction

orange & green)

The new spectrum analyzer offers the ability to measure smaller signals using our digital IF filter

Magnetic strap holster

Included accessories: sprung hook

Flash ROM: 512KB

This project holder is complete with an acrylic magnifier on an adjustable ball joint — perfect for getting a closer look at small solder points or reading the tiny print on ICs

Once the tip position is determined

Assembled Width 15 in

These safety glasses meet ANSI Z87

multi-way binding posts for isolated substitutions

Base Kit to extend your Arduino with your own wired circuit