LEAFY FRAME DIE - Gina Marie DesignsDie is approx 5. 5x4. 25 A2 sized Tips and tricks for die cutting When using steel dies I like to reccomend for machines that need 2 plastic cutting plates to keep one new and use the other to cut into. Make sure you are flipping the one your cutting into to help reduce the wave that will happen with excessive cutting. Keeping one plate new at all times helps the die not need to flex to two plates and only one. I find you typically get a better cut

Keeping one plate new at all times helps the die not need to flex to two plates and only one

The wolf die in the card example is retired

Putting it in flush can cause speed bumps on your machines roller and poor cuts in the future

You dont have to do this but if a die is proving a little more difficult it is good to try this

25 (cuts just a smidge under

ONLY THE STAMPS ARE INCLUDED

Don't buy them if you don't already have the stamps since they do with them

Smallest measures 4

25 A2 sized

please do not buy these dies

Prior to shimming a die if needed try to remove the "outer paper" and run the die back through your machine

85 inches largest layer