Acceptance Test Code for Spray Cooling Systems - ATC-133Part I Test Procedure: methods and instrumentation to determine the capability of spray cooling systems. Part II Evaluation of Results: outlines a method of evaluation of the performance of spray cooling systems from test data using performance curves. Part III Appendix: performance curve method. February 1985

An additional spray nozzle will be presented here to extend the working range of full cone nozzles

carefully cleaned

recovered and analyzed)

A new field method for enumerating viable Legionella and total heterotrophic aerobic bacteria was evaluated in hundreds of laboratory experiments and from analysis of over two thousand field samplers used in actual operating conditions

The paper will provide a basic overview of these technologies and will be focused on the needs of owners

had a mission to further reduce water consumption

The high efficiency polymer make-down system has provided Sunflower Electric Power Plant with consistent operation and greater performance of the clarifier and reduced the potential of a hazardous work environment

water chemistry requirements

This paper describes some of the non-destructive testing techniques used for structural elements in cooling towers with some case histories

The latter is often desirable for both cost of treatment and the effectiveness

and changes in salt concentration in the droplet

Any state where the EPA conducts the program