Avalanche LIDARLIDAR is back at Armabot. These handy LIDAR units have a strong 2 axis turret mount (3d printed ABS) making it easy to mount (1 inch screw spacing) and aim in the desired location then lock in place. Three ranges are available with improved detection and resolution at shorter ranges. They use an I2C protocol so they can be strung together to have multiple sensor arrays. Includes 3ft cables to connect back to your roboRIO. Outline Drawing Solidmodel

It has a single reduction 40:11 ratio with hardened steel bevel gears to the hex shaft that can support 2

Smaller bumper board sizes available to make frames with sides of 28x28"

leaving room for tucking in fabric on a 30x30" robot frame

This Ethernet cable reel has an integrated slip ring so you can keep your cable organized while your robot is on the practice field with out unplugging

Outline drawing

Outline Drawing - 1/2" Hex

Eccentric Vectored Intake Wheel Movie

Extends from 33 inches to 52 inches

The input to the drive is 3/8" or 1/2" hex bore

Solidmodel (

The total weight of the wheel assembly is 1

In the video below