Sway Bar Kit With Bushings, Rear, Hollow, AdjustableThe two primary functions of sway bars are to control body roll and to determine the understeer or oversteer behavior of a vehicle. Stock sway bars have low torsional spring rates because they are manufactured from small diameter bar stock or tubing. BMR Suspensions SB054 rear sway bar was designed by factoring in the vehicle weight, application, motion ratio, coil spring rate, and adjustability requirements. Manufactured from heavy duty 1. 25 inch

Note: This kit fits vehicles with a 4-link rear suspension setup

RED LINE C+ ATF satisfies the performance requirements of Chrysler MS7176

BMR's spring design

Sold as 1 Quart

and adding cornering consistency to your 2003-2009 Trailblazer SS or SSR is easy with upper control arms from BMR Suspension

reducing flex and bushing deflection for a more controllable vehicle

with little sacrifice to youre a-bodys street manners

Factory S197 Mustang Panhard rods are made from weak U-shaped stamped steel with soft rubber bushings that allow excessive deflection under load

Mazda 0000-77-5W30-QT

This also allows you to make instant center changes for race applications

The lowered stance and increased spring rate decreases body roll and gives you a lower center of gravity for increased driver control in aggressive cornering situations

use P/N 3003 on Moser 9”